B&K 50 Series II Manuel d'utilisateur télécharger pdf (Page 82)

At this point, the program is in a pause state. To continue the test, press once.

Note: At any time while the program is in the running state, if you wish to re-test a sequence

or test a previous sequence, press the key. Each press will go back up one

sequence and run the test again starting from that sequence. You can also skip to the

next sequence in the test by pressing .

To pause the program at any time while it is in the running state, press and then

. A Pause indicator will appear on the bottom right of the display. To resume,

repeat the same step.

When the program is in a pause state, the input state can be overridden by pressing

6. At the end of the test, the display will show:

10.000V

0.000A

PRG pass

OFF CC

10.000V

0.000A

PRG01 -01 off key pass

OFF CC

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 101 102

Pas de commentaire

B&K 50 Series II Manuel d'utilisateur Page 82