B&K 50 Series II Manuel d'utilisateur télécharger pdf (Page 61)

4. Connect the external analog control pins from the rear panel of the instrument to your

voltage control source as shown below:

Figure 13 - Analog Control Setup

5. Set the instrument to CC mode and enable the input to begin controlling with the

external voltage source.

Do not connect more than 30 V into the external program terminal pins or damages may

occur.

External Input On/Off Control

The electronic load’s input can be enabled (ON) or disabled (OFF) via the external control pins

labeled ON and ground pin ( ).

Enable (ON) input: Short the two pins together, as shown below:

Rear Panel Terminals

0 – 10 V

External Voltage Source

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 101 102

Pas de commentaire

B&K 50 Series II Manuel d'utilisateur Page 61