B&K 50 Series II Manuel d'utilisateur télécharger pdf (Page 46)

1. From the SYSTEM menu, browse and select Displ and press . The following

screen will appear.

2. Select On to enable the timer, and Off (default) to disable. Press to confirm.

3. Press twice to exit the menu. The timer will now be displayed like the following:

4. When input is enabled (ON), the timer will start counting the time. When input is

disabled (OFF), the timer will reset itself to a value close to 0 seconds.

Remote Interface Setup

The instrument has RS232, USBTMC, and GPIB remote interfaces available for remote

communication. Follow the steps below to select and configure each interface.

Note: The RMT indicator will appear on display when the instrument is successfully connected

to a PC remotely through any remote interface. Keys on the front panel will be locked until the

instrument is in LOCAL mode. To return to LOCAL mode from the front panel, press . The

RMT indicator will disappear when the instrument is in LOCAL mode.

80.000V

12.000A

0.00 W 0.0000 S CC = 1.000A

DISPLAY ON TIMER

On Off(default)

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 101 102

Pas de commentaire

B&K 50 Series II Manuel d'utilisateur Page 46