B&K 50 Series II Manuel d'utilisateur télécharger pdf (Page 64)

Figure 14 - Continuous Transient Operation Current Waveform

Pulse

In this mode, the electronic load generates a transient pulse of programmable width when

pulse transient operation is in effect.

In pulse mode, you can set A/B level, the pulse width, and A/B slew rate. The electronic load

will automatically switch to A level after maintaining A width time. Then it will switch to B level.

The electronic load will not switch to A level again until the instrument receives a trigger signal.

The following figure shows the current waveform in pulse transient operation.

Figure 15 - Pulse Transient Operation

Toggle

In toggle mode, the electronic load will switch between A level and B level when receiving a

trigger signal. The following picture shows the current waveform in toggle transient operation.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 101 102

Pas de commentaire

B&K 50 Series II Manuel d'utilisateur Page 64