B&K 50 Series II Manuel d'utilisateur télécharger pdf (Page 38)

Configure CW Parameters

There are several parameters that should be set up prior to operating in CW mode. Press

so that it lights up, then press and to access Setup for CW mode. The

setup menu will be shown:

The setup parameters are: Range, High (Voltage limit), and Low (Voltage limit). Use the

keys to select each parameter, and use the numeric keypad to change the value. Press

to confirm the change.

Range

Use the numeric keypad to change the range. This value will also act as a limit to how much

power the load can be configured to. The adjustable ranges vary depending on the model. See

specifications for details.

High

This parameter refers to the voltage high limit for the automatic test mode. During automatic

test mode, the device under test (DUT) must be operating below the configured value for the

test to PASS upon completion. If the DUT operates above the configured value, the test will FAIL

upon completion.

Note: This parameter is used for Automatic Test Function ONLY.

Low

Constant Power

Range=250.00W

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 101 102

Pas de commentaire

B&K 50 Series II Manuel d'utilisateur Page 38