B&K 2250 Light Manuel d'utilisateur télécharger pdf (Page 85)

CHAPTER 8

Advanced Use of Your Analyzer – Tips and Tricks

In the topmost line you can add other timers by tapping on the Add New Timer icon . You

can delete a timer from the list by tapping on the Delete Timer icon . Only timers created by

the current user can be deleted – to delete a timer defined by another user, you have to logon as

the other user and then delete the timer.

For each timer you can specify:

• State: Enable or disable the timer

• Name: Name the timer

• Template: Select the template you want to use for the measurement.

• Start Time: Set the start time – at least 3 minutes ahead of current time

• Preset Time: Set the preset time for the measurement – regardless of the settings in the

template used by the timer

• Stop Time: The time when the measurement stops – for information only

• No. of Starts: Set to the total number of times you want to start the measurement

• Start Every: The time interval between the start of each successive measurement. This

interval must be greater than Preset Time + 3 minutes

• User: The user who specified the timer. Cannot be changed

Note: When using timers for automatic measurements, ensure the meter is connected to a

stable power supply. It is advised to select the Ext. Power setting ‘Charge battery only’ – see

section 8.1.2 – to avoid interference with timer operation.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 211 212

Pas de commentaire

B&K 2250 Light Manuel d'utilisateur Page 85